IceCOLD® is breakthrough, engineered, synthetic refrigerant catalyst that consistently saves users up to 20% and higher on their air conditioning and refrigeration use (KWH) with 20% less annual maintenance and 20% longer equipment life.

As a revolutionary synthetic solution, IceCOLD® is safely added to a cooling system’s refrigerant to:

• Extend air conditioning systems' lives
• Ensure cooling systems run less and more efficiently
• Produce cold air faster

*Your savings may be less or more depending on the type and age of your equipment and other factors

IceCOLD® is added to an air conditioning or refrigeration system, just like adding Freon™. It provides colder vent air that cools off any space faster. As a result, a system runs less, thereby using less electricity and causing equipment to last longer since it runs less and more efficiently.

IceCOLD® removes the oil fouling by breaking the oil's surface tension. It makes the refrigerant evaporate at a lower temperature. It makes the compressor oil 54% higher in lubricity, according to data collected by INTERTEK Laboratories.

Inefficiency issues are caused by oil fouling. Refrigeration systems with mechanical compressors circulate 0.5% to 8% of their compressor lubricating oil with the refrigerant that is circulated through the system. This is where the inner walls of the refrigeration tubing are coated with a "permanent" layer of compressor oil. Due to the insulating properties of oil, the compressor oil (*add an added thermodynamic layer) insulates the hear transfer from the cold refrigerant to the heat exchange cooling walls. Oil fouling degrades all system performance by up to 20% and higher. All refrigeration compressor oils today cause oil fouling, impeding heat exchange.

Before IceCOLD® is applied, a layer of oil is attached to the walls of a compressor tubing, which significantly blocks heat transfer. When IceCOLD® is applied, this synthetic catalyst breaks the surface tension of the compressor oil, thus eliminating oil fouling and increasing heat transfer. The refrigerant then makes a positive contact with the tubing walls, promoting the transfer of heat. The IceCOLD® catalyst causes the refrigerant to evaporate at a lower temperature.

It's a trade secret synthetic compound that acts as a catalyst to make flouro carbon refrigerants evaporate at a lower temperature, which increases system capacity (BTU-more cooling). No oil fouling and lower evaporating temperature result in 15-30% increase in system capacity (BTU's). It means more and faster cooling!

IceCOLD® makes the compressor oil 54% higher in lubricity, according to INTERTEK Laboratories. It's a cutting edge PAO lubricant that is five generations newer than Mobile1 TM and it makes compressors run cooler and last longer.

In fact, 7-11 (Corporate, USA) recently reported that IceCOLD® saves 1.3 million pounds of CO2 every year at its refrigerated warehouses.

The Federal Trade Commission's Magnuson Moss Act assures that your equipment warranty cannot be cancelled, according to the Uniform Commercial Code, sections 2-314, 2-315 and section 2-313.*

• The cost of installation depends on you compressor size
• It's cost effective, because the payback is under one year
• Your ROI is at least 500%
• IceCOLD® lasts the lifetime of your system

For starters, the York Air Conditioning Company conducted a pilot study on a 25-story office building. The entire process was performed by York engineers and data was collected by them as well. They reported 28% greater efficiency over a one month period. Click to view the full report

One of them in particular (Wyndham Grand Desert) reported a $41,000 electricity cost savings in a six month period at the same time that they had 20% higher occupancy and in 6 degree hotter weather.

IceCOLD® has had both successful pilots and full installations with many major corporations.

INTERTEK showed 54% more lubricity after IceCOLD® was added. Westinghouse showed a 21.8% increase in efficiency. Independent tests were run by Idemitsu, the world's largest leading compressor oil manufacturer. York Air Conditioning manufacturing saw a 28% increase in efficiency.

Nothing. IceCold® gives you colder vent air. It will increase the energy efficiency of your A/C and/or refrigeration by 10% or more, guaranteed, or your money back. IceCold® has made thousands of installations, all of them successful.

• None are synthetic catalysts
• They do not remove oil fouling
• They do not lower evaporating temperature
• They do not significantly increase efficiency
• Some PROAs contain harmful chlorine and wax
• Some are not synthetic and should not be added to newer systems with synthetic POE and PAG

• IceCOLD® engineered refrigerant catalyst technology is NOT like any of the refrigerant additive packages offered since they were introduced in 1986.
• It is NOT an additive. It is a catalyst. Additives artfully change the oil.
• it is NOT toxic or hazardous. It can be legally shipped by air.
• It is NOT just a lubricant, like some others.
• It does NOT break down into chlorine or sulfuric acids after 1-4 years, like PROAs.
• It does NOT have any EPA disposal problems.
• It does NOT contain any form of chlorine/chlorinated compounds or sulfur/sulfinated compounds (like "PROA" additives).
• It does NOT void your equipment warranty.
• It is NOT a purchased package from an additive supplier.
• It is compatible with modern synthetic compressor oils. Mineral oil-based refrigerant additives and PROAs (the "others") and not compatible.
• It does not contain any solids like many of the additives do, such as graphite, PTFE (Teflon) or Molybdenum disulphide ("Moly").
• It does NOT have any additives that can damage the ozone layer.
• It is NOT an overbalanced TBN component (total base number).

• IceCOLD® works every time.
• The payback is under one year.
• It lasts the lifetime of the coils.
• It is a trade secret.
• It is unique because it is a catalyst.
• It is synthetic.